2510溫度控制源表設置
發布時間：2012-7-12 14:48
發布者：majake2011
|
2510型設備基于給定的溫度傳感器TEC制冷片進行編程，并設置單點溫度。在控制器將激光二極管模組穩定到目標溫度之前，首先對TEC的AC電阻進行測量和顯示。 如下是一個利用Visual Basic和吉時利488 GPIB卡控制2510-AT的實例。 ‘Reset Instruments send(kth2510, “*rst”, status) ‘reset TEC controller ‘Setup Peltier Current Limit send(kth2510, “:sens:curr:prot:lev 1.0”, status) ‘Setup Temperature Sensor send(kth2510, “:sens:temp:tran ther”, status) ‘use thermistor send(kth2510, “:sens:temp:curr:auto on”, status) ‘auto sensor current level send(kth2510, “:sens:temp:ther:range 1e4”, status) ‘10K ohm Ther. send(kth2510, “:sour:temp:spo 25.0”, status) ‘set temp. to 25C, Read Peltier AC Ohms send(kth2510, “  utp on”, status) ‘turn on outputsend(kth2510, “:meas:res:ac?”, status) ‘measure AC ohms enter(strData, 100, intLength, kth2510, status) ‘enter reading txtTECRes.Text = strData ‘display on screen ‘Begin controller Laser Diode Temperature send(kth2510, “ utp on”, status)了解吉時利2602型源表更多信息，請戳http://www.keithley.com.cn/products/localizedproducts/currentvoltage/2602/ 想與吉時利測試測量專家互動？想有更多學習資源？可登錄吉時利官方網站http://www.keithley.com.cn/ |
網友評論